Elevation And Azimuth Plane Patterns - Cisco 4G-ANTM-OM-CM Manual

Industrial routers and industrial wireless access points antenna
Hide thumbs Also See for 4G-ANTM-OM-CM:
Table of Contents

Advertisement

Cisco Aironet 5-GHz 13-dBi Directional Antenna (AIR-ANT5114P2M-N)

Elevation and Azimuth Plane Patterns

System Requirements
This antenna is designed for use with Cisco Aironet access points and bridges, but can be used with any 5 GHz Cisco Aironet
radio device that uses an N-male connector.
Safety Precautions
WARNING:
Installation of this antenna near power lines is dangerous. For your safety, follow the installation directions.
WARNING:
The warning means danger. You are in a situation that could cause bodily injury. Before you work on any equipment,
be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents.
WARNING:
In order to comply with international radio frequency (RF) exposure limits, dish antennas should be located at a
minimum of 8.7 inches (22 cm) or more from the bodies of all persons. Other antennas should be located a minimum of 7.9
inches (20 cm) or more from the bodies of all persons.
WARNING:
Do not work on the system or connect or disconnect cables during periods of lightning activity.
WARNING:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of
a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available.
WARNING:
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can come
into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits, as
they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local
codes (e.g. U.S.:NFPA 70, National Electrical Code, Article 810, in Canada: Canadian Electrical Code, Section 54).
WARNING:
Each year hundreds of people are killed or injured when attempting to install an antenna. In many of these cases,
the victim was aware of the danger of electrocution but did not take adequate steps to avoid the hazard.
240

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents