Safety Warnings - Cisco 4G-ANTM-OM-CM Manual

Cisco Multiband Indoor 4G Volcano Antenna (ANT-4G-CM-IN-TNC)

For detailed instructions on opening the door, see the installation guide of your router. Before installing the antenna
according to the Installing the
— Open the router chassis door.
— Remove any plug or connector that is installed in the antenna port.
— Verify the correct antenna port for installation, based on the antenna model you are installing.

See the installation document for your router regarding the correct antenna port location. Antennas must be installed in the
correct antenna port for ease of installation and optimal performance.
NOTE: Ensure that you are able to access the antenna port from inside the router. If an installed module prevents you from
reaching the antenna port, you might have to remove the module before installing the antenna, then reinstall the module. See
the corresponding module installation and configuration guide for each module.

Safety Warnings

WARNING: Do not work on the system, or connect or disconnect cables, during periods of lightning activity. Statement 1001
WARNING: Do not locate the outdoor antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits,
as they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local
codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada:Canadian Electrical Code, Section 54).
Statement 1052
WARNING: This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of
a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available. Statement 1024
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
WARNING: To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
WARNING: This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing
accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device. Statement 1071. SAVE THESE INSTRUCTIONS.
WARNING: This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may connect
to the Cable Distribution System ONLY through a device that is approved for direct connection. Statement 1078
WARNING: This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing
accidents.
Safety Precautions
For your safety, and to help you achieve a good installation, please read and follow these safety precautions. They may save
your life!
For your safety, read and follow these safety precautions.

If you are installing an antenna for the first time, for your own safety as well as others, seek professional assistance. Your
Cisco sales representative can explain which mounting method to use for the size and type antenna you are about to install.

Before you install an antenna, contact your Cisco account representative to explain which mounting method to use for the
size and type of antenna that you are about to install.
Antenna, you must complete these steps:
323