Mounting On A Pole - Cisco 4G-ANTM-OM-CM Manual

Cisco Aironet 2.4 GHz 13-dBi Directional Antenna (AIR-ANT2413P2M-N)

Four 1/4-in. 20x3/4 carriage bolts

Six 1/4-in. 20 hex nuts

Six 1/4-in. 20 spring lock washers

Six 1/4-in. 20 flat washers

Two pipe clamps
To attach the mount to the antenna and secure it to the pole, you need the following tools and equipment, which are not
provided.

7/16-in wrench

5/16-in nut driver or flat head screwdriver for pipe clamps
The following sections contain typical procedures for installing the antenna on a pole. Your installation may vary. Before you
begin, you may want to refer to

Mounting on a Pole

Follow these steps to mount your antenna on a pole.
1. Remove antenna and mount kit from packaging.
2. Attach antenna mount bracket to the back of the antenna as shown applying a maximum nut-tightening torque of 55 in-lbf
(6.2 Nm).
Figure 1.
120