Safety Precautions - Cisco 4G-ANTM-OM-CM Manual

Industrial routers and industrial wireless access points antenna
Hide thumbs Also See for 4G-ANTM-OM-CM:
Table of Contents

Advertisement

Cisco Multiband Panel Outdoor 3G Antenna (ANT-3G-PNL-OUT-N)
WARNING:
Do not work on the system, or connect or disconnect cables, during periods of lightning activity. Statement 1001
WARNING:
Do not locate the outdoor antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such circuits,
as they may cause serious injury or death. For proper installation and grounding of the antenna, please refer to national and local
codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada:Canadian Electrical Code, Section 54).
Statement 1052
WARNING:
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of
a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain
that suitable grounding is available. Statement 1024
WARNING:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
WARNING:
To report a gas leak, do not use a telephone in the vicinity of the leak. Statement 1039
WARNING:
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing
accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device. Statement 1071. SAVE THESE INSTRUCTIONS.
WARNING:
This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may connect
to the Cable Distribution System ONLY through a device that is approved for direct connection. Statement 1078
WARNING:
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing
accidents.

Safety Precautions

Installation of this antenna near power lines is dangerous. For your safety, follow the installation directions.
Each year hundreds of people are killed or injured when attempting to install an antenna. In many of these cases, the victim was
aware of the danger of electrocution, but did not take adequate steps to avoid the hazard.
WARNING:
For your safety, and to help you achieve a good installation, please read and follow these safety precautions. They
may save your life!
For your safety, read and follow these safety precautions.
If you are installing an antenna for the first time, for your own safety as well as others, seek professional assistance. Your
Cisco sales representative can explain which mounting method to use for the size and type antenna you are about to install.
Before you install an antenna, contact your Cisco account representative to explain which mounting method to use for the
size and type of antenna that you are about to install.
Find someone to help you—installing an antenna is often a two-person job.
Select your installation site with safety, as well as performance, in mind. Remember that electric power lines and phone
lines look alike. For your safety, assume that any overhead line can kill you.
Contact your electric power company. Tell them your plans and ask them to come look at your proposed installation.
Plan your installation carefully and completely before you begin. Each person involved in an installation should be assigned
to a specific task, and should know what to do and when to do it. One person should be in charge of the operation to issue
instructions and watch for signs of trouble.
When installing your antenna, follow these guidelines:
Do not use a metal ladder.
309

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents