Cisco 4G-ANTM-OM-CM Manual page 262

Cisco Aironet 8-dBi Omnidirectional Antenna (AIR-ANT5180V-N)
Figure 2 Antenna Port Locations
Installing the antennas depends on which type access point you are using. Two configurations are available: cable strand mount
and pole mount. Table 1 shows the antenna port usage for these configurations.
Table 1 Antenna Port Usage Table
Antenna Port
1
2
3
4
5
6
Follow these steps to connect the antenna to the access point.
1. If necessary, remove the antenna port covers.
2. Using Table 1 as a guide, align the antenna's N connector with the appropriate 5-GHz antenna port.
3. Gently push the antenna into the port.
4. Tighten the antenna hand tight.
Product Configuration
Cable Strand Mount
(Two Antenna Receive MRC Access and
One Backhaul)
2.4-GHz receive only
5-GHz transmit and receive
2.4-GHz transmit and receive
No connection
No connection
No connection
262
Pole Mount
(Three Antenna Receive MRC Access and
One Backhaul)
5-GHz receive and transmit
No connection
2.4-GHz receive only
2.4-GHz receive only
No connection
2.4-GHz transmit and receive