Mounting On A Mast - Cisco 4G-ANTM-OM-CM Manual

Cisco Aironet Dual-Band MIMO Wall-Mounted Omnidirectional Antenna (AIR-ANT2544V4M-R)
Figure 6 Mounting on a Ceiling

Mounting on a Mast

The antenna can be mounted on a mast rather than on a wall using two 1/2 inch-wide hose clamps (not provided).
To mount the antenna on a mast, follow these steps:
1. Follow Steps 1 and Step 2 from the
2. Position the antenna, mounting bracket, and hose clamps on the mast.
3. Tighten the hose clamps until the antenna is secure on the mast.
Once the antenna is secured on the mast, you can adjust the azimuth and elevation.
4. To adjust the azimuth and elevation, loosen the bolt that attaches the antenna bracket to the mounting bracket
Azimuth can be adjusted ±90 degrees. Elevation can be adjusted +15 degrees and -35 degrees.
Mounting on a Vertical Surface.
184
(Figure 5).