Appendix B Updating Firmware; Appendix C Touchpad Alignment - Awareness Technology Stat Fax 4200 Operator's Manual

9. Appendix B Updating Firmware

To update firmware, follow the instructions below. Contact your dealer or technical support if you
have any questions.
1. Erase/delete anything that is on the USB pen drive (or any USB drive used).
2. Unzip the attached file and install the folder romimage.42x on the USB drive.
3. Turn off the reader and insert the USB drive with only the one romimage.42x folder
on it into the port.
4. Place a finger on the display and then power up the reader.
5. After the instrument begins to beep you can remove your finger from the screen.
6. The update process will take about 3-5 minutes, depending upon the instrument's
bootloader version. To determine the version installed, go to Utilities – Show Version
Details.
.

10. Appendix C Touchpad Alignment

The 'TouchPad Align' feature is enabled via pass code from your Administrator. This feature
provides the ability to adjust the touchpad ranges by using the stylus or the mouse.
Selection of each of the eight squares should produce numbers on the display. If an area outside
of the acceptable range is pressed with the stylus or mouse, a sound will be produced. Each of
the pairs (top, left, bottom and right) must have a difference between them of not more than 3
points, such as on the left, 17 and 20 are good, whereas 17 and 24 are not. The SAVE button will
not appear until acceptable points have been selected. It is necessary to select SAVE in order to
store the new values.
Adjustment
square
60 Stat Fax
Touch Pad Align
Please carefully use a stylus to touch each of
the 8 small squares on the edges to help
adjust the touchpad ranges. Touch as closely
to the outside edge of the screen as possible
for best results. If the points are not close
enough (3 points apart), some pairs may be
reset.
® 4200 Operator's Manual Doc. 4200 Rev. K