Single Standard Mode - Awareness Technology Stat Fax 4200 Operator's Manual

2.5.3 Single Standard Mode

To operate in Single Standard Mode, select Manage Tests and then select Create Test.
The Test Definition screen will display. Select the mode field and the Select Mode screen
will display the list of modes. Use the arrow keys to scroll through the mode selections to
the desired selection and press Select, or use the stylus to highlight Single Standard.
The Single Standard Mode Test Definition first page will display the available options:
Name, Mode (Single Standard), Primary Filter, Differential Filter, and Blank. These
operate the same as in the Absorbance Mode except that the Blank is required, therefore
'YES' will automatically appear in the Blank enabled field.
The Single Standard Mode Test Definition 2nd page will display and allow editing of
Standard Concentration, Controls, and number of Standard Replicates. Use the arrow
keys to advance through the options and press the Edit key to change the values of the
selections on the screen.
Single Standard Mode Test Definition –2nd Page
34 Stat Fax
SELECT MODE
Absorbance
Factor
Single Standard
Point to Point
Regression
Cubic Spline
Cut Off
Select Mode screen
TEST DEFINITION
Name
Single Standard
Mode
Primary Filter
Differential Filter
Blank
Print Save
Single Standard Mode Test Definition – 1
TEST DEFINITION 2nd page
Standard Conc
# Std Replicates
Control 1
Control 2
Control 3
<< Save
® 4200 Operator's Manual Doc. 4200 Rev. K
Cancel
^
v
Select
Exit
^
405 v
630
YES Edit
>>
Page
st
Exit
10
1 ^
Disabled
Disabled v
Disabled
Edit
Run >>