Switch Setting On Ib2 Controller Interface Board; Switch Setting On Optional Eib Controller Extended Interface Board - Vertiv NetSure 7100 Series Installation Manual

Switch Setting on IB2 Controller Interface Board

Dip Switch SW1 on the IB2 board is used to set the communications address for this board. Refer to Table 1 for
SW1 settings. Refer to Figure 14 for SW1 location.
Perform the following procedure to verify the factory setting. This procedure can also be used to make
adjustment on a replacement circuit card.
Procedure
1. Ensure SW1 is set per Table 1. Refer to Figure 12 for circuit card location. Refer to Figure 14 for switch
location.
Table 1:
IB2 Controller Interface Board Switch Setting
Setting
IB2-1

Switch Setting on Optional EIB Controller Extended Interface Board

Dip Switch SW1 on the optional EIB board is used to set the communications address for this board. Refer to
Table 2 for SW1 settings. Refer to Figure 15 for SW1 location.
Perform the following procedure to verify the factory setting. This procedure can also be used to make
adjustment on a replacement circuit card.
Procedure
1. Ensure SW1 is set per Table 2. Refer to Figure 12 for circuit card location. Refer to Figure 15 for switch
location.
Table 2:
Optional EIB Controller Extended Interface Board Switch Setting
Setting
EIB-1
Vertiv | NetSure 7100 Series Installation Manual (IM582127000100) | Rev. H
DIP Switch SW1
1 2
OFF OFF
DIP Switch SW1
1 2
OFF OFF
30