Switch Settings On The Ib2 (Controller Interface Board) - Vertiv NetSure 5100 Installation Manual

Switch Settings on the IB2 (Controller Interface Board)

Dip Switch SW1 on the IB2 board is used to set the communications address for this board. Refer to Table 1 for
SW1 settings. Refer to Figure 19, Figure 20, and Figure 21 for circuit card location. Refer to Figure 23 for SW1
location.
Perform the following procedure to verify the factory settings.
This procedure can also be used to make adjustments on a replacement circuit card.
Procedure
Ensure SW1 is set per Table 1. Refer to Figure 23 for location.
1.
Table 1:
IB2 Interface Board Switch Settings
DIP Switch SW1
Setting
1 2
IB2 OFF OFF
Figure 23:
IB2 Interface Board Switch Location and Settings
Vertiv | NetSure 5100 Series Installation Manual (IM582137100) | Rev. Q 46