Switch Settings on the IB2 (Controller Interface Board) (if furnished)
Perform the following procedure to verify the factory setting.
This procedure can also be used to make adjustment on a replacement circuit card.
Communications Addressing
Dip Switch SW1 on the IB2 board is used to set the communications address for this board. Refer to Table 1 for
SW1 settings. Refer to Figure 17 for circuit card location and SW1 location.
Procedure
Ensure SW1 is set per Table 1. Refer to Figure 17 for location.
1.
Table 1:
IB2 Controller Interface Board Switch Settings
DIP Switch SW1
Setting
1
2
IB2
OFF
OFF
Vertiv
| NetSure™ 5100 Series -48 VDC Power System Installation Manual (IM582137200) | Rev. J
33