Switch Settings On Ib2 Interface Board; Switch Settings On Eib Interface Board (Primary Power Bay Only) - Vertiv NetSure 7200 Series Installation Manual

Switch Settings on IB2 Interface Board

Dip Switch SW1 on the IB2 board is used to set the communications address for this board. Refer to Table 1 for
SW1 settings. Refer to Figure 21 for circuit card location. Refer to Figure 22 for SW1 location.
Perform the following procedure to verify the factory settings. This procedure can also be used to make
adjustments on a replacement circuit card.
Procedure
[ ] 1. Ensure SW1 is set per Table 1. Refer to Figure 22 for location.
Table 1:
IB2 Interface Board Switch Settings
Setting
IB2 in Primary
Power Bay
Optional IB2 in
1st Secondary Power Bay
(if ESTOP required)
Optional IB2 in
2nd Secondary Power Bay
(if ESTOP required)

Switch Settings on EIB Interface Board (Primary Power Bay Only)

Dip Switch SW1 on the EIB board is used to set the communications address for this board. Refer to Table 2 for
SW1 settings. Refer to Figure 21 for circuit card location. Refer to Figure 23 for SW1 location.
Perform the following procedure to verify the factory settings. This procedure can also be used to make
adjustments on a replacement circuit card.
Procedure
[ ] 1. Ensure SW1 is set per Table 2. Refer to Figure 23 for location.
Table 2:
EIB Interface Board Switch Settings
Setting
EIB in Primary
Power Bay
Vertiv | NetSure 7200 Series Installation Manual (IM582127200) | Rev. K
DIP Switch SW1
1 2
OFF OFF
OFF OFF
OFF OFF
DIP Switch SW1
1 2
ON OFF
39