Vertiv NetSure 7100 Series Installation Manual page 16

Installing Battery Disconnect Circuit Breakers onto Battery Trays
Procedure
1. To install battery, disconnect circuit breakers onto battery trays, perform the procedure detailed in
Figure 3.
Figure 3:
Installing Battery Disconnect Circuit Breakers onto Battery Trays
Vertiv | NetSure 7100 Series Installation Manual (IM582127000100) | Rev. H
1. Remove the cover from the battery
2. Secure the battery disconnect circuit
Battery Disconnect
Circuit Breaker Assembly
(left side kit shown,
right side kit available)
3. After wiring to the battery disconnect
disconnect circuit breaker assembly.
breaker assembly to the battery tray
using 8-32 nuts (2-places) and #8 flat
washer (1-place) or #8 ground washer
(1-place).
circuit breaker, replace the cover.
16