Installing The Support Rails And The Storage Expansion Enclosure Into A Rack Cabinet - IBM TotalStorage DS4000 EXP700 Installation, User's, And Maintenance Manual

1. Use Table 20 on page 83 to record the location and identify your DS4000 2
2. Release the blue latch on the drive CRU by pressing on the inside of the bottom
3. Pull the handle on the tray out so that it is in the open position and pull the
Figure 13. Removing drive CRUs
4. Place the drive CRU horizontally on a level surface, with the printed circuit
5. Repeat step 1 through step 4 for additional drive CRUs.
Continue with "Installing the support rails and the storage expansion enclosure into
a rack cabinet."
Installing the support rails and the storage expansion enclosure into a
rack cabinet
To install the storage expansion enclosure in a rack cabinet, use the rails and
rack-mounting hardware that come with your storage expansion enclosure. The
storage expansion enclosure requires an EIA 310-D Type A 19-inch rack cabinet.
This required rack cabinet has a minimum and maximum rack depth of 24 inches
and 32 inches respectively, which is the distance between EIA rails, from the front
of the rack cabinet to the rear of the rack cabinet. This rack cabinet conforms to the
Electronic Industries Association (EIA) standard. Where you place the support rails
in the cabinet depends on where you intend to position the storage expansion
enclosure.
22
IBM TotalStorage DS4000 EXP700 and EXP710 Storage Expansion Enclosures: Installation, User's, and Maintenance Guide
Gb/s fibre channel hard disk drives. This record is required for replacing the
hard disk drives in the original order before they were removed.
of the tray handle.
drive out of the bay as shown in Figure 13.
Tray handle
boards facing down.
Attention: Do not stack drive CRUs on top of one another. Protect the drive
CRUs from vibrations or sudden shocks.