Table of Contents
Advertisement
2.
At the Configure window, click the Management tab. The Management page is displayed with
SNMP tab selected
Figure 49
Management page—SNMP tab
a. For each trap recipient to be configured, enter a community name of 32 or fewer
alphanumeric characters in the associated Community Name field. The community name is
incorporated in SNMP trap messages to ensure against unauthorized viewing or use.
b. Click the check box in the Write Authorization column to enable or disable write
authorization for the trap recipient (default is disabled). A check mark in the box indicates
write authorization is enabled. When the feature is enabled, a management workstation user
can change sysContact, sysName, and sysLocation SNMP variables.
c. Enter the IP address or DNS host name of the trap recipient (SNMP management
workstation) in the associated Trap Recipient field. Use 64 or fewer alphanumeric characters.
HP recommends using the IP address.
d. The default user datagram protocol (UDP) port number for trap recipients is 162. To override
this port number; click the Advanced option. The dialog box expands to show a UDP Port
Number column. Enter a decimal port number in the associated UDP Port Number field to
override the default.
3.
Click Activate to save the information. The message Your changes to the SNMP
configuration have been successfully activated is displayed.
(Figure
49).
Edge Switch 2/32 installation guide
81
Advertisement
Table of Contents
