Feed Guide Plate; Pto Speed - Welger RP 405 Operating Manual

Figure 89
76
8.7

Feed guide plate

The tear-shaped feed guide plate [1] is installed in the roll
chamber in the factory .
If a material jam occurs in case of an extraordinary crop
structure, the feed guide plate can be removed:
unscrew the right screw, seen in driving direction (arrow in
Figure 89) and remove profile from the roll chamber.
8.8

PTO speed

Operate baler at power take-off shaft nominal speed of 540
rpm.
Caution!
Only the drive shafts prescribed by the manufacturer may be
used! Protective tube and guard cone of the drive shaft, and the
power take-off shaft protection, must be fitted and be in proper
condition.
Always ensure that the drive shaft is installed and secured
correctly: Secure the drive shaft safeguard against revolving by
fitting the chain. Ensure before switching on the power take-off
shaft that nobody is within the range of danger of the device!
WELGER RP 405 • RP 435