Proper Use; Electromagnetic Compatibility - Welger RP 405 Operating Manual

WELGER RP 405 • RP 435
2.10

Proper use

• The machine is exclusively constructed for pressing bales
from agricultural straw material lying on the floor (proper
use). Using the machine for any other purposes does not
constitute proper use. The manufacturer cannot be held
liable for any damage resulting from such use; the risk of
improper use lies entirely with the user.
• Operating the machine within the limits of its proper use also
involves complying with the operating, maintenance and
servicing conditions prescribed by the manufacturer.
• The bale weight must not exceed 1.5 t. I. e. the maximum
bale size may not be available for silage bales (dependent
on the quantity of moisture the bales must be smaller). Bale
sizes: See chapter "Technical Data".
• The machine may only be used, serviced and repaired by
persons who are familiar with such work and instructed on
the dangers involved.
• Attachment of additional equipment other than at the
positions provided by the factory is prohibited. Only
additional equipment must be used that is allowed by the
manufacturer.
• The relevant accident prevention regulations and all other
generally accepted safety rules must be observed.
• Unauthorised modifications and installation of non-approved
parts and equipment on the machine preclude any liability of
the manufacturer for any damage resulting therefrom.
• Any changes to safety-relevant parts will invalidate the
conformity declaration and the CE marking.
2.11

Electromagnetic compatibility

The machine is equipped with electronic components and
modules; the function of these electronic components and
modules can be influenced by electromagnetic emissions of
other equipment. Such influences can cause risks to persons, if
the following safety instructions are not observed:
In case of subsequent installation of electrical and electronic
equipment and/or
connection to the central mains, it is the user's responsibility to
check whether the installation impairs the vehicle electronics or
any other components.
Ensure above all that the electrical and electronic components
subsequently installed are in conformity with the EMC directive
89/336/EEC as amended, and that they are provided with the
CE.
components into the machine, with
17