Tensioners; Maintenance Of The Net Tying Unit - Welger RP 405 Operating Manual

Figure 132
Figure 133
Figure 134
WELGER RP 405 • RP 435
11.3

Tensioners

Caution!
(Figure 132) The gears [2] of the main drive shaft [1] are
mounted with tensioners to the shaft end. Working at the
tensioners [3] must only performed by instructed technical staff.
11.4

Maintenance of the net tying unit

11.4.1 Adjusting the disk brake of the net tying unit
(Figure 133 and Figure 134) To prevent coasting of the net
roll the disk brake must be adjusted in such a way that the
brake disk can no more be turned by hand when the lever [1]
points upwards.
Slacken screw [2] on the lever [1], tighten milled nut [3] so
far that the brake linings are fully attached to the brake disk.
Retighten screw [2].
When brake lining [4] is worn only one-sided slacken lock
nut [5] and slightly insert screw [6] until brake linings are
parallel again, lock screw [6] again.
99