Feed Guide Plate; Pto Shaft Speed; Driving With The Baler - Welger RP 202 CLASSIC Operating Manual

1
fig. 67
10 - 20 m
10 - 20 m
richtig
correct
correct
fig. 68
WELGER RP 202 • RP 220 • RP 302 • RP 320

8.5. Feed guide plate

The streamlined feed guide plate [1] is factory installed in the roll
1742-51
chamber.
Should material become jammed due to unusual crop
conditions, then the feed guide plate may be removed. To do
this, take out screws (arrow in fig. 67) on the right side (in the
driving direction) and remove the plate from the roll chamber.

8.6. Pto shaft speed

Operate the baler with a standard pto shaft speed of 540 min
For extremely short or brittle crops, the baler can also work at
lower pto shaft speeds (350 – 450 min
Only universal drive shafts approved by the manufacturer
may be used. The protective tube and cone of the universal
drive shaft and the pto shaft protection device must be fitted and
must be in sound working order.
Always check that the universal drive shaft is correctly installed
and well secured! Secure the universal drive shaft guard by
attaching the chain to prevent it from turning! Before starting the
pto shaft, ensure that no person is within the danger zone of the
machine!

8.7. Driving with the baler

To obtain high output and well-shaped round bales, an
appropriate driving style is required so that the roll chamber is
evenly fed with material over the entire baler width.
For narrow windrows - i.e. the width of the windrow is narrower
than the pick-up unit width - uniform feeding of the bale
chamber can be achieved by driving into the left and right side
of the windrow in an alternating fashion (fig. 68).
When turning around sharp bends, ensure that the angle at the
wide-angle joint (at the tractor) does not exceed 80°. Otherwise
there is a danger of breakage during operation and at rest.
falsch
wrong
faux
-1
).
-1
.
47