Basic setting
Twine A
Twine B
Figure 29
38
5.2
Adjusting the twine brake
The twine brakes [1] (figure 25) must hold the twines as taut as
possible for the twines to be tight around the bales.
(Figure 29) Adjust dimension "X" of the twine brake
according to the following table.
Length "X" of the spring (Figure 29)
Machine with
BALERCONTROL E control
system
39 mm
37 mm
Note!
• The permitted thread tension is exceeded when the twine
breaks in the vicinity of the guide rollers [8] (Figure 29).
• The dimension "X" is measured between: washer bottom
edge and the bottom surface of the cranked plate.
Machine with
E-LINK control system
33 mm
28 mm
WELGER RP 405 • RP 435