Electrical System - Welger RP 405 Operating Manual

Figure 23
Figure 24
Figure 25
32
4.4

Electrical system

4.4.1 Lighting set
To connect the lighting system, insert the 7-pin plug into the
corresponding socket on the tractor.
Before travelling on the roads, check that the lighting system
functions correctly (also at daylight).
4.4.2 Control electronics
The machine will be delivered – according to the version – with
the following control:
• "Balercontrol E"
(with control box for "Balercontrol E" Figure 23)
• "Balercontrol III"
(with control box for "E-LINK" Figure 24)
Note! Read and heed the separate operating
instruction "E-LINK for RP 435 MASTER".
For attaching the corresponding control box a bracket is
delivered with, that must be mounted nearby the tractor
driver.
The respective control box is equipped with a magnetic plate
at the back and can be fixed onto a metallic surface into the
tractor's cabin.
To connect the control, insert the 7-pin plug into the
corresponding socket on the tractor.
After connecting the plug supply voltage is available and a short
series of beeps can be heard.
A load socket according to DIN 9680 is required on the tractor
for connecting the control electronics "Balercontrol". (Part of the
delivery of the baler). Fuse protection must amount to 30 A.
(For balers without twine tying a fuse protection of 16 A is
sufficient.)
To equip another tractor the plug socket with connecting cable
and fuse is available
0972.20.40.00.
The correct polarity of the power supply of the tractor must not
be changed, otherwise the electronic control could be damaged
(Figure 25).
under the WELGER
WELGER RP 405 • RP 435
part no.