Adjusting The Net Length - Welger RP 405 Operating Manual

Figure 51
48
6.3

Adjusting the net length

6.3.1 BALERCONTROL E
Using the scale (Figure 51) the net length (i.e. the number of
net wraps around the bale) can be adjusted continuously:
Slacken the wing nut.
Displace the wing nut in the slotted hole to adjust the desired
net length.
Retighten the wing nut.
Note!
First select a setting in the middle of the slotted hole. To save
net material change the setting step by step towards ( – ) for
subsequent bales.
Do not use too little net material: The bale must still be held
together. For very smooth bales and high baling densities a
larger amount of net material must be adjusted.
Note!
If the bale diameter changes the net length must be adjusted
accordingly.
6.3.2 E-LINK
Via the E-LINK control system the net length can be adjusted in
increments of 0.5 from 1.5 to 5 net layers (net layers are the
number of net wraps around the bale).
Note!
In case of E-LINK machines the wing nut must be installed in
the separate square hole of the scale (Figure 51) (not in the
slotted hole).
Note!
Read and observe
„E-LINK for RP 435".
the separate operating
WELGER RP 405 • RP 435
manual: