Locking The Tail Gate - Welger RP 405 Operating Manual

Figure 76
Figure 77
WELGER RP 405 • RP 435
8.1

Locking the tail gate

Before picking up of crop material is started and after every
ejection of a bale, the tail gate must be correctly locked:
Hold the tractor control valve for tail gate actuation in
"Lower" position. This will lock the tail gate automatically.
8.1.1 RP 405 SPECIAL and RP 435:
Extinguishing of the lamp [3] signals complete closing of the tail
gate.
8.1.2 RP 435 MASTER:
Complete closing of the tail gate is signalled by:
• a single beep of the E-Link control box.
• (Figure 77) The tail gate is displayed closed on the display.
• (Figure 77) The swath on the display moves towards the
machine.
Note!
To avoid unnecessary load on the hydraulic pump of the tractor:
leave the control valve in "floating position" during the baling
process.
The upper lamp [3] should only light up when the tail gate is
unlocked. Should the lamp be on also during the baling
process, the sensor setting must be checked.
The lower lamp [4] should light up only for a short time, when
the bale rolls over the bale ejector. The tail gate must not be
closed as long as the lower lamp [4] is on.
71