Net Wrapping; Inserting The Net - Welger RP 202 CLASSIC Operating Manual

fig. 32
fig. 33
fig. 34
fig. 35
32

6. Net Wrapping*

6.1. Inserting the net

In order to handle the net roll safely, insert it together with
the help of a second person!
• Open all protective covers.
• If a wrapping process has not been completely executed
(e. g. because the net roll depleted during the wrapping
process): pull the grip of the knife carrier strongly forward
against the spring tension (fig. 32). The counting segment for
the net length is reset to its starting position.
• Release
the handwheel
counterclockwise direction
• Withdraw support pipe [2] from the holder.
• Remove empty hard paper core.
• Push net tensioner [3] to the rear and secure with cotter pin.
• Insert the net roll at first angularly above the two net roll
grooves from the left side in the direction of motion (fig. 33).
• Slide the net roll onto the mandrel (on the right in the
direction of motion) (fig. 34).
• Lift net roll on the left in direction of motion, push in and lock
support pipe [2] (fig. 34).
• Align net roll laterally to the effect that it is positioned
centrally to the roll chamber.
• Remove cotter pin from net tensioner and pull net tensioner
to the front again.
• Tighten handwheel [1].
WELGER RP 202 • RP 220 • RP 302 • RP 320
[1] on the disk brake in