Electrical System; Lighting; "Balercontrol" Electronic Controller - Welger RP 202 CLASSIC Operating Manual

Balercontrol E
RP 202
RP 302
RP 220 FARMER
RP 320 FARMER
1742-37
fig. 22
fig. 23
fig. 24
26

4.4. Electrical system

4.4.1. Lighting

To connect the lighting system, insert the 7-pin plug into the
corresponding socket on the tractor. Before travelling on the
road check that the lighting system functions correctly (also in
daylight).

4.4.2. "Balercontrol" Electronic Controller

Read and follow the separate operating manual
„BALERCONTROL III with Graphic Display for RP 220/RP 320".
12 V
The control panel is provided with a plate which should be
fastened within easy reach of the tractor driver.
The control panel of the "Balercontrol" control system is also
provided with a magnetic plate on the rear and can be attached
to a metallic surface within easy reach of the driver.
Once the plug is inserted in the socket, power is supplied to the
unit and a short sequence of beeps is heard.
Note: When connecting the "Balercontrol" electronic controller,
a power socket conforming to DIN 9680 must be fitted on the
tractor. (Supplied with the baler.) The fuse rating must be 30 A.
(For baling without twine wrapping a fuse rating of 16 A is
sufficient.)
The socket with connecting cable and fuse can be supplied
under WELGER part No. 0972.20.40.00 as a retrofit part for an
additional tractor.
The correct polarity of the power supply on the tractor must not
be changed, since otherwise the electronic control unit might be
damaged (fig. 24).
WELGER RP 202 • RP 220 • RP 302 • RP 320