Table of Contents
Advertisement
If thepaperpark facilitydoesnot appearto be workingcorrectly,checkthe
following:
I
Check
I Possible remedv
I
Is the paper release lever in
The paper release lever must be set to the ~ position
the ~ position?
after the fanfold paper has been parked.
Has the fanfold paper been
Make sure that the
"PAPER OUT'
message comes on
properly pinked?
flashimz after the fanfold uaoer has been uarked.
If text is beirtgprintedall on one line, or with extra blanklines, checkthe
following:
Check
Possible remedy
Is the text all on the same
Carriage returns are not being expanded to <CR> +
tie?
<LF>
@S.
Cheek the EDS setting and correct.
Istextbeingprintedwithextra
Twolinefedsarebeingprinted.
Eithermakesure your
blank
lille.S?
software print just a carriage return or (if this is not
possible), set the AUTO LF to OFF with the EDS
setting.
Ifthepagelengthandmarginsarenotwhatis expected, c heckthefollowing:
Check
Possible remedy
1
Is
the
printing
startingtoo
Use the Micro Feed facility to adjust the print position
high or too low on the page?
relative to the page.
Doestheprinter' spagelength
Use the EDS switches to set up the correct page lengti
not match the physical page
or use software canrnands to do it.
length?
148
Advertisement
Table of Contents
