To Wire An Equipment Touch To The Mpc Open Xp - Carrier MPC Open XP Series Installation And Startup Manual

LED
The blue LED on the top of the Wireless Adapter indicates the following:
If the LED is...
Off
Blinking
Steadily on

To wire an Equipment Touch to the MPC Open XP

CAUTION If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
NOTES
•
The Equipment Touch requires a 24 Vac power supply. It is not powered by the Rnet.
•
If the Equipment Touch will be:
Daisy-chained on the Rnet with ZS sensors or a Wireless Adapter, use the standard 4-conductor Rnet
○
wiring and follow the wiring instructions To wire ZS sensors to the MPC Open XP (page 20).
The only device on the Rnet, you can use a 2-conductor cable instead of the standard 4-conductor Rnet
○
cable and follow the instructions below.
•
For complete Equipment Touch installation instructions including wiring diagrams, see the Equipment Touch
Installation and Setup Guide.
CAUTION The MPC Open XP can share a power supply with the Carrier controller as long as:
•
The power supply is AC power.
•
You maintain the same polarity.
•
You use the power source only for Carrier controllers.
1
Turn off the MPC Open XP's power.
2
Partially cut, then bend and pull off the outer jacket of the cable. Do not nick the inner insulation.
MPC Open XP
MPC Open XPIO48/816
Installation and Start-up Guide
Then the device...
Is not powered or there is a problem.
Is working properly.
Has a problem. Do one of the following:
•
Cycle power to the device.
•
Insert a small screwdriver or paper clip into the hole next to the LED to reboot the
device.
23
Installing the MPC Open XP
CARRIER CORPORATION ©2019
All rights reserved