Switch Lever - Quickstop Super; Interlock Lever - Quickstop Super - Stihl MS 362 Manual

2
: Engage lugs (2) at front end of
handle molding (1) in the
recesses (arrow).
– Press the interlock lever down.
– Push down the handle molding
(1) until it snaps into position.
– Check operation.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
10.3.1 Switch Lever –
QuickStop Super
– Remove the handle molding,
b 10.3
: Use a drift (1) to drive out the pin
(arrow).
82
1
1
2
– Lift the switch lever (1) slightly.
: Turn the switch lever (1) about
90! and pull it off the brake
cable (2).
– Check the switch lever (1) and
replace it if necessary
Installing
: Connect the brake cable (1) to
the bore (arrow) in the switch
lever.
– Turn the switch lever so that it
faces up.
1
3
: Use a drift (2) to center the switch
lever (1).
: Drive home the pin (3) until it is
recessed by same amount at
both sides.
– Reassemble in the reverse
sequence.
– Tightening torques, b 2.5
– Check operation of switch lever
1
by operating the interlock lever.
10.3.2 Interlock Lever –
– Remove the handle molding,
b 10.3
: Use a drift (1) to drive out the pin
(arrow).
– Take out the interlock lever.
1
2
QuickStop Super
1
MS 362, MS 362 C