Throttle Trigger/Interlock Lever - Quickstop Super - Stihl MS 362 Manual

1
3
2
: Use a drift (2) to center the
throttle trigger (1).
: Drive home the pin (3) until it is
recessed by same amount at
both sides.
1
: Attach the torsion spring (2) to
the interlock lever (arrow).
1
: Push the interlock lever (1) into
its pivot mounts (arrows) until it
snaps into position – check that
torsion spring is in position.
The interlock lever (1) may pop out.
80
2
: Attach the throttle rod (1) to the
throttle trigger (2) and fit it in the
guide (arrow).
1
Before installing the handle
molding, check that the insulating
tube (1) is properly positioned.
1
2
: Engage lugs (2) at front end of
handle molding (1) in the
recesses (arrow).
– Push down the handle molding
(1) until it snaps into position.
– Check operation.
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
10.3 Throttle Trigger/Interlock
Lever – QuickStop Super
: Push the tabs (1) apart and
through the tank housing.
1
1
1
MS 362, MS 362 C