10.3.3 Choke Rod - Stihl MS 362 Manual

: Push out the bushing (1).
– Remove the torsion spring.
3
– Check the interlock lever (1),
torsion spring (2) and bushing (1)
and replace if necessary
Installing
2
: Position the torsion spring (1) and
fit it in the interlock lever.
: Push the bushing (2) into the bole
(arrow) – the torsion spring is
held in position.
MS 362, MS 362 C
1
1
2
– The torsion spring (arrow) must
locate against the tank housing.
: Use a drift (2) to center the
interlock lever (1).
– Drive home the pin until it is
recessed by same amount at
1
both sides.
– Reassemble in the reverse
sequence.
2
– Tightening torques, b 2.5
– Check operation.

10.3.3 Choke Rod

– Remove the air filter, b 12.1
2
1
: Carefully pry the choke rod (2)
out of its seat in the guide (arrow)
and move the switch shaft (1) in
the direction of cold start at the
same time.
: Move the switch shaft (1) in the
direction of the carburetor and
disconnect the choke rod (2).
– Take the choke rod (1) out of the
guide.
: Disconnect the choke rod (1)
from the choke shaft (arrow).
– Check the choke rod and replace
it if necessary
Installing
1
1
: Engage the choke rod (1) in the
bore (arrow) in the choke shaft
(2).
2
1
1
2
83