Stihl MS 362 Manual page 67

Make sure that the rewind spring (1)
is properly seated and the outer
anchor loop is engaged on the lug
(arrow). If necessary, use suitable
tools to push the rewind spring fully
into its seat in the fan housing.
If the rewind spring has popped out,
refit it in the fan housing as follows:
1
– Arrange the spring (1) in its
original position.
: Fit the anchor loop in its seat
(arrow) in the fan housing.
66
1
: Fit the rewind spring (1)
clockwise in the housing.
– Hold the spring windings so that
they cannot pop out.
Make sure that the rewind spring (1)
is properly seated. If necessary, use
suitable tools to push the rewind
spring fully into its seat in the fan
housing
– Secure the spring so that it
cannot pop out.
– Install the rope rotor, b 8.4
– Reassemble all other parts in the
reverse sequence.
1
MS 362, MS 362 C