Quick Chain Tensioner; Bar Mounting Studs - Stihl MS 362 Manual

: Fit the O-ring in the spur gear
recess (arrow).
– Clean all disassembled parts with
a little standard commercial
solvent-based degreasant
containing no chlorinated or
halogenated hydrocarbons.
– Lubricate the threads, gears and
O-ring with STIHL multipurpose
grease, b 15
– Reassemble in the reverse
sequence.
5.7.1 Quick Chain
Tensioner
The quick chain tensioner is
installed in the sprocket cover.
1
: Carefully pry the wing nut (1) out
of the sprocket cover (arrow).
– Check the wing nut (1) and
replace if necessary
MS 362, MS 362 C
1
– Swing the wing nut (1) upright.
: Push the wing nut (1), thin side
first (see arrow), into the opening
and press it down until it snaps
into position.
1
2
: Take out the screw (arrow).
: Remove the cover plate (1) and
adjusting wheel (2).
When installing the adjusting wheel,
make sure its teeth face the cover
plate.
– Reassemble in the reverse
sequence.
5.8

Bar Mounting Studs

2 2
1
– Remove the side plate, b 5.2
: Push stud puller 5910 893 0506
(1) over the collar studs (2) as far
as it will go and unscrew the
studs (2) counterclockwise.
1 1
: Before installing, coat the threads
(1) of the collar studs with Loctite,
b 15
– Fit the collar studs and tighten
them down firmly.
– Tightening torques, b 2.5
– Reassemble all other parts in the
reverse sequence.
31