Stihl MS 362 Manual page 77

2
: Push the wires (1) through the
insulating tube (2).
1
– Before placing the wires in
position, make sure they are the
same length.
: Push the pins and sockets
together until they lock.
: Push the insulating tube (1) over
the connector.
– Insulating tubes must be located
in the guides (arrows).
76
1
: Push the wires into the guides
(arrows).
1
: Position the insulating tube (1) so
that it is against the edge (arrow).
2
1
: Starting from the edge (1), push
the insulating tube (2) into the
guides (arrows).
Make sure the wires are laid neatly
and straight (no loops).
2
1
: Pass the fuel hose (1) through
the opening (arrow).
– Place the air guide shroud (2) in
position.
1
: Fit and tighten down the screws
(1) firmly.
Make sure that the wires are not
pinched.
1
2
: Position the wire (1) so that the
insulating tube (2) is against the
edge of the grommet (arrow).
: Fit the wire in the guide (3).
MS 362, MS 362 C
1
3