Flywheel - Stihl MS 362 Manual

Installing
– Use a pointed tool to pierce the
center of the new ignition lead's
insulation, about 15 mm from the
end of the lead.
: Pinch the hook of the leg spring
into the pierced hole in the center
of the lead (arrow).
– Coat the inside of the spark plug
boot with
STIHL press fluid, b 15
: Hold the ignition lead and leg
spring together and push them
into the spark plug boot.
MS 362, MS 362 C
: Make sure the leg spring (arrow)
locates properly inside the spark
plug boot.
: Use a pointed tool to pierce the
center of the other end of the
ignition lead which screws into
the module.
Before installing the ignition lead, fill
the high voltage output with STIHL
multipurpose grease b 15.
Do not use either graphite grease or
silicone insulating paste.
1
– Screw the ignition lead into the
ignition module.
: Push the grommet (1) into
position.
– Install the ignition module and set
the air gap between the module
and flywheel,
b 7.6
– Reassemble all other parts in the
reverse sequence.
7.6

Flywheel

– Remove the shroud, b 6.4
– Use locking strip to block the
piston, b 4
1
: Unscrew the flywheel nut (1).
53