Pickup Body - Stihl MS 362 Manual

12.11 Fuel Intake

12.11.1 Pickup Body

Any impurities mixed with the fuel
are retained by the pickup body
(filter). The fine pores of the filter
eventually become clogged with
minute particles of dirt. This restricts
the passage of fuel and results in
fuel starvation.
In the event of problems with the
fuel supply system, always check
the fuel tank and the pickup body
first.
– Troubleshooting, b 3.6 or
b 3.7
Clean the fuel tank if necessary,
– Open the tank cap and drain the
tank.
– Pour a small amount of clean
gasoline into the tank. Close the
tank and shake the saw
vigorously.
– Open the tank again and drain it.
– Dispose of fuel properly in
accordance with environmental
requirements, b 1
106
– Open the tank cap.
: Use hook 5910 893 8800 to
remove the pickup body (1) from
the fuel tank.
Do not overstretch the fuel hose.
: Pull off the pickup body (1), check
it and replace if necessary.
– Reassemble in the reverse
sequence.
12.11.2 Fuel Hose
1
– Remove the shroud, b 6.4
– Remove the air guide shroud,
b 12.4
: Pull out the fuel hose (1) with
connector.
1
1
: Pull the fuel hose (2) off the
connector (1).
– Remove the pickup body,
b 12.11.1
: Pull the fuel suction hose (1) out
of the fuel tank.
2
1
: Inspect the fuel hose (1), fuel
suction hose (2) and connector
(3) and replace as necessary.
MS 362, MS 362 C
2
1
3