10.3.4 Throttle Rod - Stihl MS 362 Manual

1
: Position the choke rod (1) in the
guide (arrow).
– Rotate the switch shaft (2) until
the choke rod (1) snaps into
position.
– Check operation.
– Rotate the switch shaft. If
necessary, push home the choke
rod until it is properly seated.

10.3.4 Throttle Rod

– Disconnect the throttle rod from
the trigger, b 10.2
– Remove the filter base, b 12.3
1
: Pry the throttle rod (1) out of the
carburetor carrier (2).
84
2
: Pull the throttle rod in the
direction of the handle until its
bent end (1) is in front of the
opening (arrow).
: Rotate the throttle rod (1) about
90° counterclockwise. Pass the
throttle rod (1) through the
opening (arrow) in the direction of
the tank housing and remove it.
– Check the throttle rod and
replace if necessary
2
Installing
: Line up the throttle rod (1) (see
illustration).
: Push the throttle rod (1) between
the tank housing and air guide
shroud and rotate it about 90° at
the same time.
1
: Pass the throttle rod (1) through
the opening (arrow).
: Rotate the bent end (1) clockwise
and push it under the throttle
1
trigger.
1
: Push the throttle rod (1) into the
guide (2) in the carburetor carrier
until it snaps into position.
– Check operation.
– The throttle lever on the
carburetor must move upwards
when then throttle trigger is
pulled.
1
– Reassemble in the reverse
sequence.
MS 362, MS 362 C
1
2