Levers On - Stihl MS 362 Manual

1
2
4
5
Lever (1) must butt against lever (2)
and engage lever (3).
Lever (5) must engage lever (2) for
cold and warm starts
– the choke lever (5) returns to the
idle position when the throttle is
opened.
– Screw (4) must be tightened
down firmly.
The torsion springs (arrows) must
be preloaded and attached to the
levers.
98
12.6.5 Levers on Throttle Shaft
– Remove the carburetor, b 12.5
3
– Carburetor troubleshooting,
b 3.6
4
1
: Take out the screw (1).
– Relieve tension of the torsion
spring (2) and remove the lever
(3).
– Pull off the torsion spring (2) and
lever (4).
– Check the individual parts and
replace if necessary.
Installing
1
: Push the lever (1) onto the
throttle shaft as shown (arrow).
: Fit the torsion spring (1) so that
3
its leg locates against the lever
(arrow).
2
: Attach the torsion spring to the
lever (arrow).
: Place the lever (1) in position and
tighten the screw (2) moderately
– it must still be possible to turn
the lever.
: Hold the lever (2) steady.
: Rotate the lever (1) clockwise
until it butts against the stop on
lever (2) and engages the end of
the throttle shaft.
1
1 2
2
1
MS 362, MS 362 C