Chain Tensioner - Stihl MS 362 Manual

Machines with QuickStop Super
6
5
: Drive home the pins (5 and 6) as
specified below.
a
b
: Pin (5) c = about 5.9...6.1 mm
Pin (6) c = about 2.9...3.3 mm
– Reassemble all other parts in the
reverse sequence.
– Tightening torques, b 2.5
– Lubricate the brake and cam
levers, b 15
30
5.7

Chain Tensioner

– Troubleshooting, b 3.2
2
3
– Remove the side plate, b 5.2
: Turn the spur gear (2) clockwise
until the tensioner slide (1) butts
against the right-hand end and
6
the screw (3) is visible.
5
2
1
: Take out the screw (1).
– Pull out the cover plate (2) with
spur gear and support.
– If necessary, remove the O-ring.
: Take out the tensioner slide (1)
with adjusting screw.
1
2
6
2
5
– Inspect the thrust pad (3),
support (4), tensioner slide (1),
cover plate (5), spur gear set (2)
and O-ring (6) and replace as
necessary.
1
3
1
4
MS 362, MS 362 C