Rope Rotor - Stihl MS 362 Manual

1
: Remove the pawls (1).
Installing
1
– Fit the new pawls in the bores
(arrows) and lubricate the pegs
(1), b 15
: Position the spring clip (1) so that
its loops engage the pegs on the
pawls. The rounded part of the
spring clip (arrow) must engage
the starter post's groove.
: Push the straight part of the
spring clip over the starter post
until it snaps into the groove.
62
1
The spring clip's guide loops must
be in line with the pawls (arrows).
Check operation.
– Pull the starter rope, the rotor
turns and the pegs on the pawls
move in the direction of spring
loops – the pawls move
outwards.
1
– Reassemble all other parts in the
reverse sequence.
8.4

Rope Rotor

1
1
Relieving tension of rewind
spring
The system will not be under
tension if either the starter rope or
rewind spring is broken.
– Remove the fan housing and the
segment, b 8.2
: Pull out the starter rope (1)
about 5 cm and hold the rope
rotor (2) steady.
– Take three full turns of the rope
off the rope rotor.
– Pull out the rope with the starter
grip and slowly release the rope
rotor.
– Remove the starter rope or
remaining rope from the rotor,
b 8.5
– Remove the spring clip and
pawls, b 8.3
2
: Remove the cover washer (1).
Rewind spring must be relaxed.
2
: Carefully remove the rope rotor
(2).
– Check the rope rotor and replace
if necessary.
– Coat bore in rope rotor with
STIHL special lubricant,
b 15
MS 362, MS 362 C
1