Removing And - Stihl MS 362 Manual

Pressure test
1
: Push the ring (1) to the right and
connect the pump (2)
0000 850 1300 to the nipple
(arrow)
– pressurize the fuel tank.
– Operate the pump until the
pressure gauge indicates a
pressure of 0.5 bar. If this
pressure remains constant for at
least 20 seconds, the tank,
including the tank vent, is airtight.
If the pressure drops, the leak
must be located and the faulty
part replaced.
– Always install a new fuel hose.
– Reassemble in the reverse
sequence.
MS 362, MS 362 C
12.10.2 Removing and Installing
2
1
: Take out the screw (1).
1
: Take out the screw (1).
: Lower the tank housing (2).
: Slide the wooden assembly block
(1) between the crankcase and
tank housing.
Machines with Handle Heating
: Pull the wire with insulating tube
(1) out of the guides (arrows).
2
: Pry the tank vent (1) out of its
seat using the rib (arrow) for
leverage.
Always install a new tank vent.
1
– Coat sealing ring of new tank
vent with STIHL press fluid,
b 15
– Push home the tank vent by hand
until it snaps into position.
– Reassemble all other parts in the
reverse sequence.
1
1
105