Throttle Trigger/Interlock Lever/Switch Lever (036 Qs) - Stihl 034 Series User Manual

Fit the handle molding so that the
lug at its front end engages
properly under the seat on the
tank housing.
– Fit handle molding fastening
screw (see "Tightening
Torques").
034, 036, 036 QS
9.3

Throttle Trigger/Interlock Lever/Switch Lever (036 QS)

2
1
– Remove the air filter -
Unscrew fastening screw (1)
from handle molding (2). Lift
away the handle molding.
1 2
Use a 3 mm drift to drive the
needle roller (2) out of the
interlock lever (1). Remove the
lever.
3
2
1
Use a 4.5 mm drift to drive the
bushing (1) out of the interlock
lever (2) and then remove the
torsion spring (3).
Install in the reverse sequence.
1
To remove the switch lever (1),
see 12.1.
swing it back (arrow).
Disconnect brake cable (1) from
switch lever (2).
– Use a 3 mm drift to drive the
needle roller out of the switch.
– Take out the switch lever.
Install in the reverse sequence.
1
2
45