Ethernet Wan Setup - D-Link Router User Manual

Section 3 - Configuration
On this page you can configure your Ethernet WAN connection. This would be used if you have an Internet connection from a DSL, Cable, or
other external source. Note that, by default, the 4G connection is used as your primary connection. If you are not sure which settings to use,
please contact your Internet Service Provider (ISP).
Internet Connection Settings
Profile Name: Displays the name of the current profile.
WAN Link Indicates the interface used by the WAN connection. As of this
Type:
writing, only Ethernet is available.
Enable: Enable or Disable the interface.
LinkMode: Choose a link speed for the Ethernet interface. The default and
recommended setting is Auto.
Enable If your WAN interface uses a VLAN ID, select Enable and fill out the
Default Vlan: following two section. Otherwise, select Disable.
Default VLAN If enabled, enter the default VLAN ID.
ID:
Default VLAN
If enabled, enter the default VLAN priority.
Priority:
Internet Settings
Select an Internet connection type for your Ethernet WAN. This information should
be provided by your ISP.
If you have chosen PPPoE, see PPPoE (Username / Password) on page 14.
If you have chosen Dynamic IP, see Dynamic IP (DHCP) on page 17.
If you have chosen Static IP, see Static IP on page 18.
If you have chosen Bridge Mode, see Bridge Mode (RFC-1483 Bridged) on page
19.
D-Link DWR-961 User Manual

Ethernet WAN Setup

13