Accessories | Spare Parts - Kemper KHS Mini Control System MASTER 2.0 Installation And Operating Instructions Manual

Status
Status LED
LED
Operating cycles
exceed 20,000
Thermal disinfection
limit exceeded
Set-point max. limit
exceeded
Set-point min. limit
undercut
Frost protection limit
undercut
Set-point OK
Control in standby
Flushing is running

Accessories | Spare parts

Optionally available accessories
KHS VAV with servo drive 230 V
KHS VAV plus with spring-reset servo drive (230 V)
KHS drain with overflow monitor
KHS temperature sensor fitting Pt 1000
KHS flow measurement valve
Leakage water sensor
K410068602008-00 / 09.2018
Description of warnings / notices
Status LED
Warnings
The VAV on the defective SLAVE
has performed more than 20,000
operating cycles
The monitored temperature has
exceeded the set limit value.
The monitored temperature has
exceeded the set limit value.
The monitored temperature has
undercut the set limit value.
The monitored temperature has
undercut the set limit value.
Notes
Notice that the monitored
temperature is in the target
range.
No flushing pending. Control in
standby
The valve on the involved control
is flushing / is open.
71
Status LED
Replace VAV bonnet in
accordance with the
maintenance manual
and reset the operating
cycles.
Check to see if it needs
to be set otherwise.
Check to see if it needs
to be set otherwise.
Check to see if it needs
to be set otherwise.
Prevent danger of
valves freezing up.
No action needed!
No action needed!
No action needed!
FIGURE
686 04
686 05
688 00
628 0G / 629 0G
638 4G / 138 4G
620 00 001
Status LED
The warning message
cannot be confirmed.
SLAVE continues to
operate normally.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
Entry in logbook and
optional message via
email.
No influence
Entry in logbook.