Acknowledge Error; Usb Interface - Kemper KHS Mini Control System MASTER 2.0 Installation And Operating Instructions Manual

Acknowledge error

All the errors that occur in the system are
sent to the KHS Mini Control System -
MASTER 2.0-
acoustically by means of a buzzer. It is
possible to integrate an alarm relay (see
Chapter 2.2). In normal operation, the
alarm relay is energized ("pulled") with
voltage. If there is an error, the voltage
1
2
3

USB interface

K410068602008-00 / 09.2018
and are signalled
drops and an acoustic signal reports the
error. Here it does not matter what
different effect the error has on the
system. The control goes into alarm
latching and has to be acknowledged by
the user after the malfunction has been
repaired.
Data can be transmitted comfortably with
the USB interface of the KHS Mini Control
System MASTER 2.0-. Data can be
imported by the device and also exported
from the device. It is also possible to use
the USB stick to install updates not only
for the Control System but also for the web
browser.
The USB menu is not visible in normal
mode. The menu
activated when a USB memory stick is
connected to the KHS Mini Control System
-MASTER 2.0-.
 Max. storage capacity of the USB stick
16 GB
 File system FAT32
30
A detailed list of
possible errors and
their corrections is
given in chapter 7.
is automatically