Setup Options - AMX HDMI-UTPRO-0808 Instruction Manual

Unlocking the Control Panel
When the panel is locked and you press any key, the Unlock Panel screen appears and you have ten (10) seconds to enter
the password, or the control panel remains locked. If you wait longer than 10 seconds, press any key again before
entering the password.
If you enter the wrong password while attempting to unlock the control panel, an invalid password message appears and
the Cancel Key flashes. Press the Cancel Key to clear the error and then enter the correct password.
The following example uses the default password of "1 2 3 4 1" entered using the first five keys in the top row (Inputs 1,
2, 3, 4 and Output 1).
To unlock the control panel:
1.
Press any key. The Unlock Panel screen appears, and the Input and Output Keys turn blue.
Important: You must enter the password within ten (10) seconds.
2.
In the following order, press Input Keys 1, 2, 3, 4 and Output Key 1 (default password).
The panel unlocks and returns to the Function menu.

Setup Options

The following options are available under the Setup Options submenu:



Note: The submenu options Default VM and Reload Config do not normally apply to the HDMI UTPro unless
the configuration file has been modified (see page 110 and page 119).
Checking the Software Version (Software Version Screen)
The Software Version screen provides the following information:





To check the software version information for the control panel:
1.
Press the Function Key.
The Function menu appears.
2.
Locate Setup Options by scrolling with the Control Dial.
Instruction Manual – HDMI-UTPRO-0808
Software Version – to display software version information for the control panel
Default VM – to change the factory default virtual matrix
Reload Config – to load local presets information to the control panel after they are created in XNConnect
Driver – control panel's firmware version
Built – date the control panel's software was built
Host – software version of the initial operating system (IOS) for the control panel
XNet ID – control panel's XNet device number
FP Link baud 115200 – indicates a front control panel and the baud rate
Operating the Control Panel
56