AMX HDMI-UTPRO-0808 Instruction Manual page 97

HDMI-UTPRO-RX SERIAL SEND_COMMANDs (continued)
set baud rate with
SET BAUD
SEND_COMMAN
Set the serial
D
communication parameters.*
TSET BAUD
Set the serial
communication parameters.*
TXCLR
Stop and clear all
characters waiting in the
transmit out buffer and stops
transmission.
* Both commands for setting the baud rate are accepted by the Receivers and work the same way. When the system is
rebooted or power cycled, the serial ports default to 9600, N, 8, 1.
Instruction Manual – HDMI-UTPRO-0808
Syntax:
SEND_COMMAND <DEV>,"'SET BAUD <baud>,<parity>,<data>,<stop>'"
Variables:
• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200.
• parity = N (none), O (odd), E (even)
• data = 8 data bits
• stop = 1 and 2 stop bits
Example:
SEND_COMMAND dvRXRS232,"'SET BAUD 19200,N,8,1'"
Temporarily sets the RX serial port's communication parameters to
19200 baud, no parity, 8 data bits, 1 stop bit.
Syntax:
SEND_COMMAND <DEV>,"'TSET BAUD <baud>,<parity>,<data>,<stop>'"
Variables:
• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200.
• parity = N (none), O (odd), E (even)
• data = 8 data bits
• stop = 1 and 2 stop bits
Example:
SEND_COMMAND dvRXRS232,"'TSET BAUD 19200,N,8,1'"
Temporarily sets the RX serial port's communication parameters to
19200 baud, no parity, 8 data bits, 1 stop bit.
Syntax:
SEND_COMMAND <DEV>,"'TXCLR'"
Example:
SEND_COMMAND dxRXRS232,"'TXCLR'"
Clears and stops all characters waiting in the RX serial port transmit buffer.
HDMI-UTPRO-RX NetLinx Programming
97