Hdmi-Utpro-Rx Netlinx Programming; Overview; Device Numbering - AMX HDMI-UTPRO-0808 Instruction Manual

HDMI-UTPRO-RX NetLinx Programming

Overview

The HDMI-UTPRO-RX Receiver recognizes a select number of NetLinx CHANNELs and SEND_COMMANDs.
NetLinx programming is supported only if the HDMI-UTPRO-RX is connected to the HDMI UTPro (a native NetLinx
device).




Device Numbering

In NetLinx Studio's Online Tree, the HDMI UTPro is listed as a device with a single port, and each HDMI-UTPRO-RX
Receiver connected to the HDMI UTPro is listed as a separate device immediately following the HDMI UTPro (the
default device number for the HDMI UTPro is 05500; refer to the Device Numbering section on page 83 for details).
Note: Only RX units that are physically connected to the HDMI UTPro will be represented in the Online Tree.
The device number for each HDMI-UTPRO-RX currently connected to the HDMI UTPro is automatically designated a
device number, based on the device number of the HDMI UTPro to which it is connected and on the number of the
UTP OUTPUT port (1-8) on the HDMI UTPro to which it is physically connected.
Therefore, it important to avoid assigning device numbers that will conflict with this auto-numbering scheme. Reserve
the eight device numbers following the HDMI UTPro's device number assignment for up to eight HDMI-UTPRO-RX
Receivers.
In NetLinx Studio's Online Tree, each HDMI-UTPRO-RX Receiver displays three ports (FIG. 61).
FIG. 61
NetLinx Studio Online Tree - Ports 1-3 on first three connected HDMI-UTPRO-RX Receivers
The three ports relate directly to the three types of NetLinx commands recognized by the HDMI-UTPRO-RX:



Note: For additional information on using NetLinx Studio, refer to the "Programming Guide – NetLinx
Integrated Controllers" (available at www.amx.com).
Instruction Manual – HDMI-UTPRO-0808
The main Device SEND_COMMANDs are described on page 92.
IR SEND_COMMANDs are described on page 93.
SERIAL SEND_COMMANDs are described on page 96.
Ports 1-3 on HDMI-UTPRO-RX
(device number 05501)
Ports 1-3 on HDMI-UTPRO-RX
(device number 05502)
Ports 1-3 on HDMI-UTPRO-RX
(device number 05503)
Port 1 - SEND_COMMANDs
Port 2 - SERIAL (RS232) SEND_COMMANDs
Port 3 - IR SEND_COMMANDs
HDMI-UTPRO-RX NetLinx Programming
Port 1 - main device port
Port 2 - Serial (RS-232) port
Port 3 - IR device port
91