Webconsole Troubleshooting - AMX HDMI-UTPRO-0808 Instruction Manual

WebConsole Troubleshooting

Check the following:
Be sure all power, signal, and link connections on all of the equipment are secure.

Be sure the HDMI UTPro is correctly plugged into a network with a DHCP server.

Be sure the LEDs on the LAN 10/100 connector indicate activity and that the Ready LED is illuminated.
 
Be sure the LED indicators on the NetLinx Master are functioning.

Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XX.XX (where XXX.XXX.XX.XX is the

FIG. 55
Example of typical response when system is pinged
Try the following:
Try connecting to the WebConsole again.

If the WebConsole still does not open, you may need to add an exception in the Proxy Setting dialog box

Tip: Also check "Installation Troubleshooting" on page 43 and the troubleshooting information in the
documentation for the NetLinx Master.
Instruction Manual – HDMI-UTPRO-0808
HDMI UTPro IP address).
For an example of a typical response showing verification of communication with the HDMI UTPro,
see FIG. 55.
(see instructions on the next page).
HDMI UTPro WebConsole
80