AMX HDMI-UTPRO-0808 Instruction Manual page 38

RS-01 Adapter Cable (FG-RS01)
The adapter cable can be ordered by itself for a DCE interface with female connection.

FIG. 26
DCE interface with female connection
Serial Port (RJ-12) Pinout
The following table provides the pinout configuration for the RJ-12 connector (Serial port) on the HDMI-UTPRO-0808
and also on the HDMI-UTPRO-RX Receiver.
RX RJ-12 Pinout
Function
Data Set Ready
Transmit Data
Receive Data
Signal Ground
Signal Ground
Data Terminal Ready
To connect an external serial device:
1.
Plug the RJ-12 end of the adapter cable into the Serial port on the HDMI UTPro
(or Receiver).
2.
As needed – Connect cable adapter(s) per the desired Cable Kit option on the
previous page.
3.
Plug the DB-9 end of the adapter cable (or the end cable adapter) into the serial
port on the external device.
4.
Check to be sure that the device's serial port settings and serial port settings on the enclosure (see table to the right)
correspond to each other. If necessary, the default settings on the HDMI UTPro can be changed; see page 87.
Caution: To avoid system damage, follow the power-up sequence on page 40.
Instruction Manual – HDMI-UTPRO-0808
Serial port as DCE interface with female connection:
Abbreviation
DSR
TD or TX or TXD
RD or RX or RXD
GND
GND
DTR
DB-9 Serial Port Pinouts
(female connector)
RS-232
Pin 2: TX signal
Pin 3: RX signal
Pin 5: GND
Female
RJ-12 Connector
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Installation and Setup
HDMI UTPro
RJ-12 Port Settings
Baud Rate 9600
Data Bits 8
Parity None
Stop Bits 1
Flow Control None
38