Splash Screen Examples - AMX HDMI-UTPRO-0808 Instruction Manual

Splash Screen Examples

Note: AMX reserves the right to add to the contents of the splash screen at any time, without notice.
Power-Up Splash Screen
The first example is of the splash screen that displays when power is applied to the enclosure. When "Ready" appears,
BCS commands can be entered for executing switches, verifying status, querying the system for diagnostic information,
etc.
[1:Enclosure] HDMI-UTPRO-0808 v1.4.1 R
Ready
FIG. 70
Power-up splash screen in terminal emulation program
Splash Screens Displaying System Information
Following are four examples of splash screen information that could be displayed when different verbosity/component
settings are specified. Depending on the amount of detail provided, you may need to scroll to see the entire display. The
command in the first example can be used to check the host software (IOS) version and the hardware driver (appcode)
version.
~scrv3i1!
[1:Enclosure] HDMI-UTPro-0808
[host software] v3.4.2
[hardware driver] v1.4.1 R
[build date] Mar 8 2010 14:24:14
[xnet address] 0x02c4
[ap system id] 0x0
[nvram status] valid.. user preferences restored
[nvram magic] 0xdedafaba
FIG. 71
Display for v3i1 (verbosity 3, component 1)
Instruction Manual – HDMI-UTPRO-0808
Appendix B – Programmer's Interface for System Diagnostics
Firmware version
108